Cutting Accuracy and Cutting Speed Control of Water Cutter

The  is machined by using ultra-high pressure technology. The waterjet can be used to cut soft-based materials by pressurizing ordinary tap water to 250-400 Mpa pressure, and then spraying it out through a gem nozzle with an inner hole diameter of 0.15-0.35 mm. The high-speed jet with a speed of about 800-1000 m/s can be formed. The market will generally increase abrasives to improve the cutting ability of water cutting, such as the combination of pomegranate sand, water and pomegranate sand, can form a huge penetration force.

Waterjet can be used to cut two-dimensional shapes, including metal, ceramics, plastics, stone, glass and carbon fibers, and can even produce complex and fine shapes. Compared with other cutting methods, waterjet can remove material without heat, so that the debris of material can be washed away by cutting water, which improves the cutting efficiency.

The cutting speed and precision of water cutter are two closely related parameters. Only when the cutting accuracy of water cutter is satisfied, can the speed be further pursued. Because of the short cutting platform, it is difficult to judge whether the highest speed can be achieved by eyes. In this case, we can use the software simulation work matched by the servo driver of the cutting machine. To see if the motor speed is the highest.

Generally speaking, the acceleration and deceleration of water cutter can be improved without actual cutting when testing the cutting speed of water cutter; each axis can be tested separately or simultaneously. In addition, the accuracy of water knife cutting is generally required to be less than (+0.5mm) for construction industry, but less than (+0.Olmm) for automotive reflectors, and the lower the cutting requirement for steel plate processing, the better.